SW RAID mode supports configuration of SATA ports for RAID via RAID configuration software.įor RAID 0, 1, and 10, enclosure management is provided through the SATA_SGPIO connector on the server board when a cable is attached between this connector on the server board and to the backplane or I2C interface. Note: For AHCI capability in EFI, you should set the AHCI legacy Option ROM to ―disabled‖. AHCI mode supports all SATA ports using the Advanced Host Controller Interface when the option is enabled. COMPATIBILITY mode supports up to four SATA ports with IDE Legacy mode and two SATA ports with IDE Native Mode. ENHANCED mode supports up to six SATA ports with IDE Native Mode. The modes affect the configuration as follows: When this option is enabled, you can set the ―SATA Mode‖ option to ENHANCED mode, COMPATIBILITY mode, AHCI mode, or SW RAID mode. The ―Onboard SATA Controller‖ option is enabled by default. The BIOS Setup utility provides multiple drive configuration options on the Advanced | Mass Storage Controller Configuration setup page, some of which affect the ability to configure RAID.
0 Comments
Leave a Reply. |